What problems should be paid attention to when installing the household switch socket panel?
For the installation of household switch socket panels, here are the following two suggestions for everyone. Because the basic requirements of the routine have been answered with everyone in the above question and answer. Therefore, here we focus on the following two points.
①: Before installing the switch socket panel, the bottom box must be cleaned. That is, we must clean the bottom box, and do not allow a lot of putty powder, cement mortar, etc. in the bottom box. The presence of these substances will corrode our wires and affect the use of switch socket panels.
②: The length of the wire in the bottom box must be kept long enough. Because when we install the switch socket panel in the bottom box, we generally need to pull out some wires, and then install the wire to the terminal block of the switch socket panel. If the wire is short, it is difficult for us to connect the switch socket panel after the wire is pulled out of the bottom box. Moreover, even if it is connected, the connection is not strong, and it is easy to cause shaking, and the virtual connection does not meet the requirements.
